Before First Use Of The Mini Barista Espresso Machine - Sunbeam EM4300 User Manual

Before First Use of the Mini Barista Espresso Machine

Step 1. Remove Packaging
Ensure all packaging has been removed.
Important: Remove the red Plug found
at the base of the Water Reservoir.
Step 2. Position Machine
Ensure the espresso machine is always
positioned onto a dry, stable, flat horizontal
bench top.
Step 3. Wash Parts
Wash the 8 parts listed below in warm
water with a mild detergent.
- Stainless Steel Milk Jug
RETURN
- Stainless Steel Drip Tray Grill
- Stainless Steel One Cup Filter Basket
- Stainless Steel Two Cup Filter Basket
Important: Below 4 parts are
NOT DISHWASHER SAFE:
- Group Handle
- Drip Tray
- Tamper
- Water Reservoir
Rinse and dry each part thoroughly then
place on the machine.
Step 4. Prime the Machine
Important: Priming must be completed
prior to first use.
• Fill Water Reservoir
- Push back the Lid to open.
- Fill with room temperature water.
or
- Remove the reservoir by opening the Lid,
& lifting upwards using the Handle inside.
- Fill with room temperature water from
the tap.
- Replace the Water Reservoir firmly into
position & close the Lid.
Note: Make sure that the Water Reservoir
is clean and free of any debris, as any
fine particles can block the water flow.
MAX
2L
1 L
MIN
MAX
2L
1 L
MIN
• Power
ONE
CUP
Ensure that:
- DIAL is in the vertical READY position.
- Insert the Power Plug into a 230-240V AC
power outlet & turn the power on.
- Press the ON/OFF BUTTON to start the
machine.
The ON/OFF LIGHT will illuminate & pulse
to indicate it is warming up.
When both the ON/OFF & READY LIGHTS
are fully illuminated, the machine is ready.
• Insert Group Handle
- Place the Two Cup Filter Basket in the
Group Handle.
- Insert the Group Handle into the Group
Head.
ON / OFF
To ensure that the Group Handle is in the
correct position, align the Group Handle
with the 'INSERT' position located on the
left of the Group Head.
Insert the Group Handle flat against the
Group Head, then turn the Group Handle
right all the way to the centre position.
• Prime the Machine
- Turn the DIAL to the TWO CUP setting &
allow the water to run through.
READY LIGHT flashes when DIAL needs to
be returned to the vertical position.
- Do this once more.
Now the machine should be thoroughly
primed and ready to use.
If water does not run through the Group
Head, contact Sunbeam Customer Care.
Details are on the back page.
TWO
CUP
READY
ON / OFF
HOLD
4 SEC
READY
LIGHT
5