HP SimpliVity OmniCube CN-3400 Installation And Maintenance Manual page 13

Callout Component
4 System identification
button
5 IPMI port
6 Serial port
7 Video connector
8 USB connectors
9 10GbE ports
10 1GbE ports
11 Power supplies
12 Boot drives
Description
System identification button and system identification
connector.
The system identification button helps you locate
a system within a rack. If you push the system
identification button on the back panel or the front
panel, the system identification buttons on the front
panel and the back panel flash blue. Push a system
identification button a second time to stop it from
flashing.
The system identification connector, located to the
right of the system identification button, connects the
optional system status indicator assembly through the
optional cable management arm.
Dedicated IPMI port for remote, out-of-band, web-
based management.
Serial port that you can use to connect a serial device.
Video connector that enables you to connect a monitor
or keyboard, video, monitor (KVM) device.
Two USB 3.0 compliant ports for connecting USB
devices to the system.
Two 10GbE network interfaces, numbered 1 and
2. Each 10GbE interface has link (top) and activity
(bottom) round LEDs. These interfaces are dedicated
to SimpliVity Storage and Federation networks.
Two 1GbE network interfaces, numbered 3 and 4,
from left to right. Each 1GbE interface has link (left)
and activity (right) square LEDs. These interfaces are
dedicated to the Management network and, optionally,
VM traffic.
Two redundant, 750W or 1100W power supplies
with fans, numbered 1 and 2, from left to right. Each
power supply has a status indicator light in the handle.
Disconnect the power cords before removing a power
supply. Wattage depends on the CPU requirements
(number of cores).
Two hot-swappable 2.5" hard drives. Reserved
for system use and are not available for user data
storage.
Hardware components 13