Message List - Yamaha EAD10 Owner's Manual

Message List

Message
Are you sure?
Auto power off disabled.
Backup error.
Cancel AUX IN recording?
Canceled.
Can't use RECORDER now.
Completed.
Connecting USB device...
Excessive demand for USB power.
Factory Reset initializing...
File already exists.
File not found.
Illegal file.
Incompatible USB device.
Invalid USB device.
No data.
No response from USB device.
Now importing...
Now loading...
Now processing...
Now saving...
Now switching audio driver.
Overwrite?
Description
Confirms whether or not you want to execute the specified operation.
Appears when the [STORE] button is held down while turning on the
power informing the user that the Auto Power Off function is dis-
abled.
Appears when writing data to the Flash ROM has failed.
If data was not be properly saved when turning off the unit, this mes-
sage appears the next time the power is turned on. After the error
message appears, the Factory Reset automatically executes.
Appears when the SOURCE button is pressed while the Recorder is
in AUX IN Recording. Press the button below "YES" to return to the
normal Recorder setting.
Appears when the cancel operation is complete.
Cannot use the recorder because "USB To Host" is set to "audio."
Check the "USB to Host" setting.
Appears when execution of a Scene Store, File Load/Save, Job, or
other function is complete.
Appears when connecting to a USB device.
Power consumption of the USB device exceeds the specified value.
Appears on startup if you did a factory reset.
A file with the same name already exists.
The selected file type was not found.
Appears when loading a file and the Main Unit cannot handle the tar-
get file or does not support the audio file.
Appears when an unsupported USB device is connected to the [USB
TO DEVICE] terminal.
The USB device is faulty. Format the USB device again.
Appears when the target data does not exist when using the
Recorder or using Wav-related parameters under "Job."
There is no response from the USB device.
Appears when importing a .wav file.
Appears when loading a file.
Appears when executing a Scene Store or Job operation. Appears
during post-processing after canceling the File Load or File Save
operation.
Appears when saving a file.
Appears when the [USB TO HOST] terminal is connected to a com-
puter or other device and the following operation is performed.
When changing the "USB To Host" setting to "MIDI" or "MIDI+audio."
When entering or exiting the Recorder screen when the "USB To
Host" setting is "auto."
Appears when saving a file to the USB device and a file with the
same name already exists in the USB device.
Appears when attempting to rerun the Store User Scene operation
for the Scene previously saved.
Reference
Message List
EAD10 Owner's Manual 61