Table of Contents
Advertisement
OSD description
• Fan Speed
Use this function to control the projector's cooling fan. You can set it to Normal or High. The
default setting is Normal.
Under normal circumstances, the projector will operate normally with this function set to Normal.
By default, the projector will detect the temperature of the surrounding environment to regulate the
speed of the cooling fan. When the ambient temperature rises, fan speed will increase (generates
louder noise) to make sure the heat inside the projector gets discharged and keep the projector
working normally.
However, if you were to operate the projector in environment of excessive heat or in areas of
high altitude, the projector may automatically shut down. When this happens, you can enable
this function by setting it to High to force the cooling fan to work at a full speed to regulate the
temperature inside the projector.
Note: We recommend selecting high speed in high temperatures, high humidity, or high altitude
(higher than 1520 meters (5000 feet)) areas. Please refer to Page Page 76.
Note: Due to the air thinning substantially at high altitudes, the result of cooling achieved by
the cooling fan is significantly reduced compared to operation on level ground. With low
atmospheric pressure and high operating temperature, the cooling fan will not be able to
disperse the heat adequately.
Note: When change fan speed need to re-turn on the projector again.
• Laser Info
Press ENTER / ► to enter the Laser Info menu to display the laser hours for each laser mode.
• Remote ID
Press ◄► to select remote ID to fit the current remote ID settings. Refer to Page 21 : "Remote
control".
Note: Remoter with Default customer code will be available for any Remote ID setting on the
OSD.
Note: Status key will be available for any Remote ID setting on the OSD
Note: IF users forget the current Remote ID setting, please press the Status key to call out the
Status OSD to check the current Remote ID setting and then adjust the ID on the remoter
to meet the OSD setting.
Note: After adjusting Remote ID from OSD, only if the OSD Menu has been closed then the new
ID value can be taken effected and memorized.
Note: The setting value "Default" means ID 0 on the remoter.
• Network
Press ENTER / ► to enter the Network menu.
• Network State
Projector Control: Choice this fuction to control the projector via the web.
On: This function only for the professional service person. For download command use.
• DHCP
If the projector installation environment has the Dynamic Host Configuration Protocol server.
You can set this function "ON" to let the projector get the auto ID from server. If no DHCP, even
you set "ON" for this function. You still need to input the projector ID by yourself.
• IP Address
If has DHCP server and the function is on. The ID address will auto display here , or you need to
enter ID by yourself.
• Subnet Mask
If has DHCP server and the function is on. The Subnet Mask address will auto display here , or
you need to enter it value by yourself.
English-62
Advertisement
Table of Contents
