Auto Source - Dukane 8965WUSS User Manual

OSD description
Settings 2

Auto Source

• ON
By enabling this function, the projector will automatically determine the source of input every time
it is turned on so that the user will not have to make the selection on the OSD menu.
• OFF
Setting the function off will require the user to specify source of picture input on the OSD menu in
order for the projector to display the intended picture.
No Signal Power Off
Allows the projector to turn off automatically if no input signal is detected after a set period of time.
When this setting is set to 0, this function is invalid.
Auto Power On
If you set this function to On, the light source will be automatically turned on without usual
procedure, when the AC power is cut off during the light source was on and it is supplied again.
The light source will not be turned on automatically even when the AC power is supplied after the
following procedures. Please turn on the light source with the usual procedure.
• The light source was turned off with the normal procedure.
• The light source was turned off when this function is set to Off.
Laser Mode
• Normal
Brightness will be 100% when set to Normal mode. If the projection environment requires brighter
picture, you can set the power mode to Normal for the highest projection brightness.
Note: When the temperature is higher than 35°C (95°F) , the brightness will be 60%
automatically.
• Eco
When set to Eco mode, the brightness will be 80% of the normal brightness.
• Eco Plus
When set to Eco Plus mode, the brightness will be 60% of the normal brightness.
• Dimming
When set to Dimming mode, the brightness will be 40% of the normal brightness.
English-60