Reset All - Dukane 8965WUSS User Manual

• Extreme Dimming
When set to Extreme Dimming mode, the brightness will be 25% of the normal brightness. The
cooling fan will slow down the speed. If the surrounding environment is sufficiently dark or if you
do not require intense brightness, you can set the power mode to Extreme Dimming to save the
power.
• Custom Light
If the picture brightness at Extreme Dimming mode is too dark for you and the Normal mode
gets too bright, you can set it to custom to specify the power mode to make fine adjustments to the
brightness of the projected picture. You could encounter situations where the picture from projector
A being brighter than projector B. When this occurs, you can use this function you could encounter
situations where the picture from projector A being brighter than projector B. When this occurs,
you can use this function to fine tune the brightness of the two projectors to achieve consistent
picture brightness. To access this function, go to the MENU  Settings 2  Laser Mode 
Custom Light and adjust accordingly.

Reset All

Press ENTER / ► to reset all settings to default values.
Note: All of OSD function are reset to default except Language, Security Lock, Source,
3D(include Sync Invert & Format), Test Pattern, Remote ID, Network.
Status
Press ENTER / ► to enter the Status menu.
• Active Source
Display the activated source.
• Video Information
Displays resolution/video information for RGB source and color standard for Video source.
• Laser Hours
Laser hour used information is displayed.
• Software Version
Showing system software version.
• Remote ID
Showing Remote Controller ID.
• Serial Number
Showing serial number of product.
Advanced 1
Press ENTER / ► to enter the Advanced 1 menu.
• Menu Position
You can use this function to designate which area on the picture the OSD menu will appear. As you
can see from the diagram below, there are five positions where you can choose to have the OSD
menu displayed. The default setting is "Center".
• Translucent Menu
Press ◄► to enter and select OSD background translucent level.
• Low Power Mode
Press ◄► to enter and turn Low Power Mode On or On By Lan.
Note: About "On By Lan", RJ45 will support to be waked up in this mode(Under 3W) but scalar
won't.
OSD description
English-61