JUKI DDL-8100B-7 Series Instruction Manual page 23

(3) Constant-dimension stitching pattern
The constant-dimension stitching pattern can be set.
[How to set the constant-dimension stitching]
* Straight stitching
1) Enable/disable of the constant-dimension stitching pattern can be changed over by pressing
.
When the constant-dimension stitching pattern is enabled, LED Ⓞ lights up.
Immediately after the constant-dimension stitching is enabled, the numbers of reverse feed stitching pro-
cesses (A, B, C and D) are displayed on the display section Ⓐ.
 is pressed, the content shown on display section is changed over to the number of
2) When switch
stitches for the constant-dimension stitching.
The number of stitches (0 to 99) for the constant-dimension stitching can be selected by pressing
switch .
* Others
1) Enable/disable of each stitching pattern can be changed over by pressing
❽ or switch ❾.
Immediately after one of the stitching patterns is enabled, the numbers of reverse feed stitching process-
es (A, B, C and D) are displayed on the display section Ⓐ.
 is pressed, the display section Ⓐ changes its display to the number of stitches for
2) When switch
the constant-dimension stitching process (EF) is displayed.
The number of stitches for the process (EF) can be set by pressing
3) Then, the content shown on display section Ⓐ is changed over to the number of stitches for the con-
stant-dimension stitching process (GH) by pressing switch
The number of stitches (0 to 99) for the process (GH) can be set by pressing
 is pressed, the content shown on display section Ⓐ is changed over to the num-
4) When switch
bers of stitches for the reverse feed stitching processes (A, B, C and D).
.
– 21 –
switch
switch ❼,
switch
switch .
switch .