Chrysler 300 2016 User Manual page 34

G E T T I N G S T A R T E D
Power Lumbar
Vehicles equipped with power driver or passenger seats may also be equipped with power lumbar.
The power lumbar switch is located on the outboard side of the power seat. Push the switch
forward or rearward to increase or decrease the lumbar support. Push the switch upward or
downward to raise or lower the lumbar support.
Driver Memory Seat
This feature allows the driver to store up to two different memory profiles for easy recall through
a memory switch. Each memory profile contains desired position settings for the driver seat, side
mirrors, adjustable pedals (if equipped), and power tilt and telescopic steering column (if
equipped) and a set of desired radio station presets. Your remote keyless entry key fob can also
be programmed to recall the same positions when the unlock button is pushed.
NOTE:
If your vehicle is equipped with two key fobs, one key fob can be linked to memory position 1 and
the other key fob can be linked to memory position 2.
The memory seat switch is located on the driver's door trim panel. The switch consists of three
buttons: The (S) button, which is used to activate the memory save function and the (1) and (2)
buttons which are used to recall either of two pre-programmed memory profiles.
Programming The Memory Feature
To create a new memory profile, perform the
following:
1. Place the ignition into the RUN position.
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror, adjust-
able pedals [if equipped], power tilt and
telescopic steering column [if equipped],
and radio station presets).
3. Push and release the S (Set) button on the
memory switch.
32
Power Lumbar Switch
Driver's Memory Buttons