Auto Source - BenQ MX731 User Manual

Returns all of the adjustments you've made for the Display menu to the factory
Reset Display
preset values.
Network
Wireless LAN
See
BenQ product webpage.
Wired LAN
AMX Device When this function is On, the projector can be detected by AMX controller.
Discovery
MAC Address
(Wireless)
Displays the mac address for this projector.
MAC Address
(Wired)
Settings
Projector The projector can be installed on a ceiling or behind a screen, or with one or more
mirrors. See
Installation
Remote Allows you to enable all the remote receivers or one specific remote receiver on
the projector.
Receiver
• Allows the projector to automatically search for a signal.

Auto Source

Search
The following signal source(s) will not be automatically detected by the projector, and you'll have to
manually select it from the source selection bar: Network Display, USB Reader.
• On: Allows the projector to automatically determines the best picture timings for
Auto Signal
Adjustment
• Off: The projector will not respond when AUTO is pressed.
• Lamp Mode: See
Lamp Settings • Reset Lamp Timer: See
• Lamp Timer: Displays the number of hours the lamp has been used.
Quick Cooling:
Selecting On enables the function and projector cooling time will be shortened
from a normal 90-second duration to approximately 15 seconds.
Blank Timer
Operation
Settings
Sets the image blank time when there is no action taken on the blank screen, once
elapsed the image will return to the screen. If the preset time spans are not suitable
for your need, select Disable. No matter Blank Timer is activated or not, you
can press most of the keys on the projector or remote control to restore the
picture.
36 Menu operation
BenQ Network Projector Operation
Choosing a location on page
the displayed image when PC signal (analog RGB) is selected and AUTO is
pressed.
Setting the Lamp Mode on page
Guide, which can be downloaded from
12.
Resetting the lamp timer on page
42.
45.