Table of Contents
Advertisement
Check the connection between
the CN102 and the CN104.
(Because it is impossible to
check it afterward)
PWB assembly Sensor
Install the PWB assembly Sensor upon completion of the work shown below.
Connect CNTH to E950 connector of PWB
assembly Sensor
E950
PWB assembly Sensor
CNTH
Pass this through a notch of the
PWB holder.
TSW
Let the CNPOW and TSW cables cross each other
(so that the TSW will not approach the primary side
power circuit).
CNPOW
CNTH
Affix TAP3 after checking connection of E950
connector (so that it will not come off).
TAP3
CNPWR
CNBAR
When connecting the CNBAR
to the CN2 connector, check
and make sure that the
connector is completely inserted.
When connecting the CNPWR connector to the CN1
connector, make sure they are completely locked.
Advertisement
Table of Contents
