Page 1
Projector CP-S335/X340/X345 User's Manual – Quick Guide Thank you for purchasing this projector. WARNING ►Before using, read the "User's Manual - Safety Guide" and these manuals to ensure correct usage through understanding. After reading, store them in a safe place for future reference.
Page 2
Arrangement Arrangement Arrangement WARNING ►Install the projector in a suitable environment according to instrictions of the "User's Manual - Safety Guide". CAUTION ►This projector has some intake vents also on the bottom. Avoid blocking vents. Put nothing that is sucked or sticks to the bottom of projector. (c) up 16:9 (c) down...
Adjusting the projector's elevator / About the fi lter cover for bottom - up use Adjusting the projector's elevator Adjusting the projector's elevator WARNING ►Do not adjust the projector’s elevator during use or immediately after use. Handling while the projector is in a high temperature could cause a burn and/or malfunction to the projector.
Connecting your devices Connecting your devices Connecting your devices Examples of connection with a computer * AUDIO IN1 RGB cable is linked to RGB IN1. Stereo mini audio cable AUDIO IN1 AUDIO OUT RGB IN1 RGB IN2 RGB OUT AUDIO IN2 VIDEO Audio out USB(A) RGB out...
Page 5
Connecting your devices Examples of connection with a VCR/DVD player AUDIO IN1 Audio out Video out AUDIO OUT RGB IN1 RGB IN2 RGB OUT AUDIO IN2 VIDEO S-VIDEO COMPONENT VIDEO CONTROL Video cable Stereo mini audio cable AUDIO IN1 Audio out S-Video out AUDIO OUT RGB IN1...
Connecting the power supply / Putting batteries into the remote control Connecting the power supply Connecting the power supply WARNING ►Please use extra caution when connecting the power cord as incorrect or faulty connections may result in fi re and/or electrical shock. •...
Operating Operating Operating WARNING ►When the power is on, a strong light is emitted. Do not look into the lens or vents of the projector. Turning on the power POWER Set the power switch to the ON position. (Solid orange) POWER POWER Press the STANDBY/ON (projector or...
Page 8
Lamp Lamp Lamp WARNING HIGH VOLTAGE HIGH TEMPERATURE HIGH PRESSURE ►The projector uses a high-pressure mercury glass lamp. The lamp can break with a loud bang, or burn out, if jolted or scratched, handled while hot, or worn over time. Note that each lamp has a different lifetime, and some may burst or burn out soon after you start using them.
Page 9
Lamp (continued) When the indicators or a message prompts you to replace the lamp, replace the lamp as soon as possible. Turn the projector off, and unplug the power cord. Allow the lamp to cool for at least 45 minutes. To prepare a new lamp, contact your dealer and tell the lamp type number = DT00671.
Air fi lter Air fi lter Air fi lter WARNING ►Before caring, make sure the power switch is off and the power cable is not plugged in, then allow the projector to cool suffi ciently. The care in a high temperature state of the projector could cause a burn and/or malfunction to the projector.