Setup Of Pc; Connection - Furuno VR-3000 Instruction Manual

This manual describes how to setup VR-3000/S after installation. The outline of the
setup is;
Step 1. Network setting on PC
Step 2. Connection of PC
Step 3. Software configuration
Step 4. Making a backup copy of configuration data
Step 5. Initialization of index file
After setting up, make a backup copy of configuration data onto the compact flash card
and your PC. The system transfers the configuration data from compact flash card to
the DRU if no configuration data is found in the DRU at startup.
Parts and Equipment needed
1) PC with web browser, Internet Explore 6.0.
2) Ethernet cross cable

1 Setup of PC

Before connecting to VR-3000/S, set the IP address and subnet mask of the PC as
below. The IP address of VR-3000/S is 10.0.0.100.
Procedure for Windows 2000 / XP
1. Click Start, Settings, Control Panel and Network and Dial-up Connections.
2. Click Local Area Network, Properties and Internet Protocol (TCP/IP).
3. Click the Properties button.
4. Choose "Use the following address".
5. Enter IP address and subnet mask:
IP address: 10.0.0.102 or 10.0.0.99 (other than 10.0.0.100)
Subnet mask: 255.0.0.0
6. Click the OK button and then click it again.
7. Restart PC.

2 Connection

A PC is connected to the DCU as shown in Fig.2.1 for system setup.
A PC with a web browser is connected to J14, Live Player port in the DCU with an
Ethernet cross cable.
Data Collecting Unit
Terminal Board
(J14 Live Player)
Fig.2.1
Ethernet Cross Cable
1
PC