Bluetooth Setup - Mira Advance Installation Manual

Bluetooth Setup

Mira Advance Flex Extra (J09N) for use with the Instantmatch by
Whale® Digital Pump
Flex Extra J09N
OFF
48º C Factory setting &
Bluetooth transformer connection
LK2 Set to ON
Important Information Regarding Bluetooth Range!
Correct operation of the shower and pump relies on the strength of the bluetooth signal between
them. You must install the Whale Pump and Bluetooth transformer as advised in the Whale
Instantmatch installation guide. Failure to do so may cause the shower & pump not to pair or
go into an error mode resulting in intermittent or complete failure to operate.
For retrofit installations where a Whale Bluetooth transformer is fitted in place of a RF wireless
transformer then testing for correct operation must be carried out before final install.
Note! Metal objects such as steel baths, sinks, foil lined plaster board or solid walls can
reduce the operational range. Where a Bluetooth signal cannot be established the pump and
shower should be hardwired.
BEAB ON/OFF
43 DEG C
45 DEG C
RESERVED
6L/MIN
PUMP LK3
PUMP LK2
PUMP LK1
ON
BEAB
43 DEG C
45 DEG C
RESERVED
6L/MIN
PUMP LK3
PUMP LK2
PUMP LK1
Instant Match Bluetooth Transformer
SDS236T (755.678)
The bluetooth operation of the Advance Flex Extra (J09N)
will only work with a Whale bluetooth transformer. Pre-
vious Whale RF wireless transformers will not connect
to the bluetooth Advance.
Note! Suitable Bluetooth transformer can
be identified by blue start/stop button.
1 2 3 4 5 6 7
Jumper Settings for Bluetooth Pairing
Please refer to 'Bluetooth Pairing' to link the shower to
the 'Whale' bluetooth transformer (SDS236T - 755.678)
19
1 2 3 4 5 6 7 10 30 60 1 2
10 30 60
1 2
1306246-W2-A