Clarity C120 User Manual page 8

R
TV
W
FIG. 5
STEREO MONO
TV
3.5mm jack
FIG. 6
Co m p u t e r
FIG. 7
CD Pl a y e r
FIG. 8
M P 3
Pl a y e r
FIG. 9
MIC
FIG. 10
FIG. 11
8
TM
C120 OPERATION
2. Mono Mode:
This mode should be used if the television
(or other audio equipment) has only one audio
RCA or a 3.5mm jack.
This enables the C120™ to be used with
computers, CD players, stereos, mp3 players,
and other related products.
If the television, or other device, has only one
RCA port, connect the left (white) RCA plug
from the output into the left (white) RCA jack
of the base. The right (red) jack should remain
unplugged. See Figure 5.
If the television, or other device, has a 3.5mm
jack, use the cord with the RCA jacks on one
end and 3.5mm jack on the other. Plug the
3.5mm into the device and plug the RCA jacks
into the C120™ base. See Figures 6-9.
Next, select "Mono" on the Mono/Stereo
switch.
3. Microphone Mode:
Use this mode only if an RCA connection is not
available. For example, older televisions do not
have audio outputs. In this case, the micro-
phone should be used. Connect the supplied
microphone into the "Mic" jack on the back of
the base, as illustrated in Figure 10. Place the
microphone near the speaker of the television
or stereo.
Note: The microphone may pick up any sound
in the room, such as speech, the doorbell, or
the telephone. (Fig. 11)