Prepare Hood For Installation - GE JVW5301, JVW5361 Installation Instructions Manual

Installation Instructions
PREPARE HOOD FOR INSTALLATION
i.
Remove the grease filters from the unit and
set aside. The grease filters are removed
by pressing the handle
in front of the filter.
When replacing, make
sure that the filters are
properly positioned with
the handles in front and
visible.
2. Remove and properly discard the protective
plastic wrapping from the hood and grease
filters.
3. Remove junction box cover.
Vented Installations
1. Securely press damper on top of the exhaust
opening. Check that the damper opens freely.
2. Go to Mount the Range Hood in this section.
Non-vented Irecirculation)Installations
NOTE: Recirculation duct (included) and charcoal
filters JXCF72 (not included) are required. The
damper is not installed on the unit with
recirculation installations.
1. Install the non-vented (ductless) recirculation
duct (A) supplied with the vent hood,
B
Non-vented {recirculation)Installations
(Continuedl
2. Check that the recirculation duct is in the correct
orientation with the hole towards the front of
the hood. Fit the recirculation duct over the vent
exhaust outlet (B) and push down to seat on the
outlet.
3. Go to Mount the Range Hood in this section.
NOTE:
Hole must
be facing
toward front
of hood.
MOUNT THE PYRAMID RANGE HOOD
.
Install the range hood body by placing the
hood key holes over the mounting screws. Feed
the power supply cable through the electrical
knockout. Tighten the mounting screws.
Mounting
Screw Slots
2. Insert 2 mounting screws into the 2 duct cover
anchors (installed on line D in Preparing the
Wall section)located in the slots on the back
surface of the hood. Secure tightly.
3. Connect the house ducting to the damper
on the hood body if ducted install. Seal all
connections with duct tape.
NOTE: If recirculation installation, skip to Step 4
and proceed.
4. Install the upper duct cover. __-
Slightly spread the sides of . _ .....
the cover apart and hook
them behind the duct cover
mounting brackets. Attach
the cover to the brackets
with 4 duct cover screws.
!
Z
¢/9
I--
I--
!
0
Z
!
Z
¢/9
-t
C
-4
!
0
Z
31 10983
7