HP EliteDesk 705 G3 Hardware Reference Manual page 31

16. Grasp the WLAN module (2) by the sides and pull it out of the socket.
17. Insert the new WLAN module into the socket on the system board.
NOTE: A WLAN module can be installed in only one way.
18. Press the WLAN module connectors firmly into the socket (1).
19. Press the WLAN module down to the system board and use the included screw to secure the module (2).
20. Match the label on each antenna cable to the corresponding connector on the WLAN module and attach
the antennas (3) to the connectors.
21. Press the hood sensor (1) firmly into place.
22. Set the hard drive cage (2) into the chassis.
Replacing the WLAN module 25