HP A7500 Series Configuration Manual page 88

<Sysname> ftp 10.1.1.1
Trying 10.1.1.1 ...
Connected to 10.1.1.1.
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User(10.1.1.1:(none)):abc
331 Give me your password, please
Password:
230 Logged in successfully
# Set the file transfer mode to binary.
[ftp] binary
200 Type set to I.
# Download the system software image file newest.app from the PC to the device.
Download the system software image file newest.app from the PC to the root directory of the
•
storage medium on the active MPU of the IRF fabric (that is, the active MPU on the master).
[ftp] get newest.app
Download the system software image file newest.app from PC to the root directory of the storage
•
media of the standby MPUs of the IRF fabric (that is, any MPU except the active MPU of the IRF
fabric) (the member ID and slot number of the member switch where one standby MPU resides are
both 1; the member ID and slot number of the member switch where another standby MPU resides
are 2 and 0 respectively; the member ID and slot number of the member switch where the third
standby MPU resides are 2 and 1 respectively).
[ftp] get newest.app chassis1#slot1#flash:/newest.app
[ftp] get newest.app chassis2#slot0#flash:/newest.app
[ftp] get newest.app chassis2#slot1#flash:/newest.app
# Upload the configuration file config.cfg of the device to the server for backup.
[ftp] ascii
[ftp] put config.cfg back-config.cfg
227 Entering Passive Mode (10,1,1,1,4,2).
125 ASCII mode data connection already open, transfer starting for /config.cfg.
226 Transfer complete.
FTP: 3494 byte(s) sent in 5.646 second(s), 618.00 byte(s)/sec.
[ftp] bye
# Specify newest.app as the main system software image file for next startup of the active MPU of the IRF
fabric.
<Sysname> boot-loader file newest.app chassis 1 slot 0 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 1
slot 0!
# Specify newest.app as the main system software image file for next startup of the standby MPUs of the
IRF fabric.
<Sysname> boot-loader file chassis1#slot1#flash:/newest.app chassis 1 slot 1 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 1
slot 1!
<Sysname> boot-loader file chassis2#slot0#flash:/newest.app chassis 2 slot 0 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
81