HP A7500 Series Configuration Manual page 42

To do...
Configure the data
bits
Define a shortcut
key for enabling a
terminal session
Define a shortcut
key for terminating
tasks
Configure the flow
control mode
Configure the type
of terminal display
Configure the user
privilege level for
login users
Set the maximum
number of lines on
the next screen.
Set the size of
history command
buffer
Use the command...
databits { 5 | 6 | 7 |
8 }
activation-key
character
escape-key { default |
character }
flow-control
{ hardware | none |
software }
terminal type { ansi |
vt100 }
user privilege level
level
screen-length
screen-length
history-command
max-size value
35
Remarks
Optional
By default, the data bits of the console port is 8.
Data bits is the number of bits representing one
character. The setting depends on the contexts to
be transmitted. For example, you can set it to 7 if
standard ASCII characters are to be sent, and
set it to 8 if extended ASCII characters are to be
sent.
Optional
By default, you can press Enter to enable a
terminal session.
Optional
By default, you can press Ctrl+C to terminate a
task.
Optional
By default, the value is none.
The switch supports the none flow control mode
only.
Optional
By default, the terminal display type is ANSI.
The device supports two types of terminal
display: ANSI and VT100. HP recommends you
to set the display type of both the device and the
client to VT100. If the device and the client use
different display types (for example, hyper
terminal or Telnet terminal) or both are set to
ANSI, when the total number of characters of the
currently edited command line exceeds 80, an
anomaly such as cursor corruption or abnormal
display of the terminal display may occur on the
client.
Optional
By default, the default command level is 3 for the
AUX user interface.
Optional
By default, the next screen displays 24 lines.
A value of 0 disables the function.
Optional
By default, the buffer saves 10 history
commands at most.