Configuring Scheme Authentication For Modem Dial-In - HP MSR Series Configuration Manual

The next time you attempt to dial in to the device, you must provide the configured login password, as
shown in Figure
Figure 34 Password authentication interface for modem dial-in users

Configuring scheme authentication for modem dial-in

Follow these guidelines when you configure scheme authentication for AUX login:
• To make the command authorization or command accounting function take effect, apply an
HWTACACS scheme to the intended ISP domain. This scheme must specify the IP address of the
authorization server and other authorization parameters.
If the local authentication scheme is used, use the authorization-attribute level level command in
•
local user view to set the user privilege level on the device.
• If a RADIUS or HWTACACS authentication scheme is used, set the user privilege level on the
RADIUS or HWTACACS server.
To configure scheme authentication for modem dial-in users:
Step
1. Enter system view.
2. Enter AUX user
interface view.
3. Enable scheme
authentication.
34.
Command
system-view
user-interface aux first-number
[ last-number ]
authentication-mode scheme
59
Remarks
N/A
N/A
Whether local, RADIUS, or
HWTACACS authentication is
adopted depends on the configured
AAA scheme.
By default, password authentication
is enabled on AUX user interfaces.
By default, no authentication is
performed on AUX user interfaces.