Configuring None Authentication For Telnet Login - HP MSR Series Configuration Manual

Table 15 Configuration required for different Telnet login authentication modes
Authentication
mode
None
Password
Scheme

Configuring none authentication for Telnet login

Step
1. Enter system view.
2. Enable Telnet server.
3. Enter one or multiple
VTY user interface
views.
4. Enable none
authentication mode.
5. Configure the
command level for
login users on the
current user interfaces.
6. Configure common
settings for the VTY
user interfaces.
The next time you attempt to Telnet to the device, you do not need to provide any username or password,
as shown in
and the message "All user interfaces are used, please try later!" appears.
Configuration tasks
Set the authentication mode to none for the VTY user
interface.
Enable password authentication on the VTY user
interface.
Set a password.
Enable scheme authentication on the VTY user interface.
Configure local or remote authentication settings.
To configure local authentication:
16. Configure a local user and specify the password.
17. Configure the device to use local authentication.
To configure remote authentication:
18. Configure the RADIUS or HWTACACS scheme on
the device.
19. Configure the username and password on the AAA
server.
20. Configure the device to use the scheme for user
authentication.
Command
system-view
telnet server enable
user-interface vty first-number
[ last-number ]
authentication-mode none
user privilege level level
See "Configuring common VTY
user interface settings
(optional)."
Figure 13. If the maximum number of login users has been reached, your login attempt fails
Remarks
N/A
N/A
N/A
N/A
By default, the default command level is 0 for
VTY user interfaces.
Optional.
34
Reference
"Configuring none
authentication for Telnet
login"
"Configuring password
authentication for Telnet
login"
"Configuring scheme
authentication for Telnet
login"