Garmin GPS 400 Pilot's Manual And Reference page 88

SECTION 5
PROCEDURES
NOTE: If the pilot needs to lose extra altitude or
speed by going around the holding pattern again,
press the OBS Key to manually suspend waypoint
sequencing before crossing the holding waypoint
the second time. If this waypoint has already
been passed, re-activate the holding pattern
using the steps described in Section 5.2.
Figure 5-33 Approach Mode
5-12
DO NOT USE FOR
NAVIGATION
GPS 400 Pilot's Guide and Reference
Refer to Figure 5-33 for the following steps.
11) When approaching BODRY intersection, a
waypoint alert ('APPRCHING WPT') appears
in the lower right corner of the screen (Figure
5-34).
Figure 5-34 Waypoint Alert
12) At 2.0 nm from the FAF (DEPOY intersection),
the GPS 400 switches from terminal mode to
approach mode. CDI scaling is tightened from
1.0 to 0.3 nm, full scale deflection.
190-00140-60 Rev. E