Identification - ABB REC670 Applications Manual

Section 16
Logic
16.2.1
16.2.2
16.2.3
16.3
16.3.1
492

Identification

Function description
Trip matrix logic
Application
The trip matrix logic TMAGAPC function is used to route trip signals and other logical
output signals to different output contacts on the IED.
The trip matrix logic function has 3 output signals and these outputs can be connected
to physical tripping outputs according to the specific application needs for settable
pulse or steady output.
Setting guidelines
Operation: Operation of function Enabled/Disabled.
PulseTime: Defines the pulse time when in Pulsed mode. When used for direct tripping
of circuit breaker(s) the pulse time delay shall be set to approximately 0.150 seconds in
order to obtain satisfactory minimum duration of the trip pulse to the circuit breaker
trip coils.
OnDelay: Used to prevent output signals to be given for spurious inputs. Normally set
to 0 or a low value.
OffDelay: Defines a delay of the reset of the outputs after the activation conditions no
longer are fulfilled. It is only used in Steady mode. When used for direct tripping of
circuit breaker(s) the off delay time shall be set to at least 0.150 seconds in order to
obtain a satisfactory minimum duration of the trip pulse to the circuit breaker trip coils.
ModeOutputx: Defines if output signal OUTPUTx (where x=1-3) is Steady or Pulsed.
Logic for group alarm ALMCALH
Identification
Function description
Logic for group alarm
IEC 61850 IEC 60617
identification identification
TMAGAPC -
IEC 61850 IEC 60617
identification identification
ALMCALH -
1MRK 511 401-UUS A
SEMOD167882-2 v3
ANSI/IEEE C37.2
device number
-
M15321-3 v12
M15291-3 v5
GUID-64EA392C-950F-486C-8D96-6E7736B592BF v1
GUID-64EA392C-950F-486C-8D96-6E7736B592BF v1
ANSI/IEEE C37.2
device number
-
Bay control REC670 2.2 ANSI
Application manual