ABB SM2000 User Manual page 16

...2 OPERATION
...2.5 Digital Indicator View
Totalizer stop/go
Ch 1.1 Level
Ch 1.2 Pressure
Ch 1.3 In Flow
Ch 1.4 Out Flow
Stop
Ch 1.5 Temp
Go
Ch 1.6 Alarm 1
All
Totalizer reset
Ch 1.1 Level
Ch 1.2 Pressure
Ch 1.3 In Flow
Ch 1.4 Out Flow
Ch 1.5 Temp
Ch 1.6 Alarm 1
Alarm acknowledge
Ch 1.1 Level
Ch 1.2 Pressure
Ch 1.3 In Flow
Ch 1.4 Out Flow
Ch 1.5 Temp
Ch 1.6 Alarm 1
All
AutoView Scroll
14
Stop and start individual totalizers.
Channel totalizers that have not been enabled in the configuration level are shown greyed
out.
Note. When a totalizer is not running (i.e. Stop is selected), the corresponding totalizer
value is shown in red.
Reset the totalizer value to the totalizer preset value.
Note. Channel totalizers that have not been enabled in the Configuration level are shown
greyed out.
Acknowledge active alarms individually, in the current process group or globally.
Note. Active alarms are identified by a flashing red 'Alarm Status' icon in the bottom left
hand corner of the associated channel indicator and a Global Alarm icon in the title bar –
see Fig. 2.5. If the Global Alarm icon is surrounded by a flashing red border, an active alarm
is unacknowledged.
If neither alarm on a particular channel is configured, the short channel tag is greyed-out in
the menu.
Select AutoView Scroll to display the chart for each configured process group in turn for 40
seconds. The AutoView Scroll icon (
screen when AutoView Scroll is active. Press any key to cancel AutoView Scroll.
) is displayed in the status bar at the top of the