Toyota Celica Supra 1986 Service And Repair Manual page 384

AUTOMATIC TRA.NSMISSION - Assembly of Transmission AT-109
18. INSTALL THRUST WASHER ON OVERDRIVE CASE END
Coat the thrust washer with petroleum jelly and set it into
place facing the lip side toward the overdrive case.
19. INSERT OVERDRIVE CASE INTO TRANSMISSION CASE
Insert the overdrive case gently through the two guide bolts
(SSTI with the circled part in the figure facing in the direc-
tion indicated.
20. INSTALL TWO THRUST WASHERS
Coat the thrust washers with petroleum jelly. Install one
thrust washer on the overdrive case and the other one on
the overdrive clutch.
NOTE: The washer lugs should be inserted in the holes.
21. INSTALL OVERDRIVE CLUTCH IN CASE
Align the flukes of the discs in the overdrive case. Align
the flukes with the slots of the overdrive clutch and press
the overdrive clutch into the overdrive case.
CAUTION:
Be
careful that the thrust washer does not tal
out.
22. CHECK CORRECT INSTALLATION OF OVERDRIVE
CLUTCH
Set SST on the overdrive case as shown in the figure. Mea-
sure the distance between the top surface of SST and the
overdrive clutch. If the distance corresponds to that dur-
ing disassembly, the overdrive clutch is installed correctly.
SST 09350-20013 (09370- 12010)
Helghi: Measure value minus SST width
=
Approx. 3.6 mm (0. 138 ln.)