Yamaha Super Tenere XTZ12H 2016 Owner's Manual page 81

1. O-ring
TIP
Make sure that the O-ring is properly
seated.
10. Install the new oil filter cartridge
with an oil filter wrench, and then
tighten it to the specified torque
with a torque wrench.
Periodic maintenance and adjustment
1
1. Torque wrench
Tightening torque:
Oil filter cartridge:
17 N·m (1.7 kgf·m, 12 lb·ft)
11. Install the cowling.
12. Install the engine oil drain bolts
and their new gasket, and then
tighten the bolts to the specified
torques.
Tightening torques:
Engine oil drain bolt (crankcase):
20 N·m (2.0 kgf·m, 14 lb·ft)
Engine oil drain bolt (oil tank):
20 N·m (2.0 kgf·m, 14 lb·ft)
13. Refill with the specified amount of
the recommended engine oil.
7-14
Recommended engine oil:
See page 9-1.
Oil quantity:
Oil change:
3.10 L (3.28 US qt, 2.73 Imp.qt)
With oil filter removal:
3.40 L (3.59 US qt, 2.99 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
 In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
 Make sure that no foreign mate-
rial enters the crankcase.
14. Check the O-ring for damage, and
replace it if necessary.
ECA11621
7