Single-Slot 2U Node Pci Riser Cage Assembly Option - HP APOLLO 2000 User Manual
Hide thumbs
Also See for APOLLO 2000:
- Maintenance and service manual (178 pages) ,
- Maintenance and service manual (136 pages)
Table of Contents
Advertisement
13. Connect all peripheral cables to the node.
14. Power up the node.
Single-slot 2U node PCI riser cage assembly option
Procedure
1.
Power down the node.
2.
Disconnect all peripheral cables from the node.
3.
Remove the node from the chassis.
4.
Place the node on a flat, level surface.
5.
Remove the 2U rear I/O blank.
6.
If you are installing an expansion board, remove the PCI blank.
7.
Install any expansion board options.
8.
Connect all necessary internal cabling to the expansion board. For more information on these cabling
requirements, see the documentation that ships with the option.
9.
Do the following:
a. Install the single-slot 2U node PCI riser cage assembly and secure it with two T-10 screws.
Single-slot 2U node PCI riser cage assembly option
97
Advertisement
Table of Contents
