Low-Profile Lff Hot-Plug Drive Led Definitions - HP APOLLO 2000 User Manual

Item LED
4 Drive status
The blue Locate LED is behind the release lever and is visible when illuminated.
IMPORTANT:
The Dynamic Smart Array B140i Controller is only available in UEFI Boot Mode. It cannot be enabled in
Legacy BIOS Boot Mode. If the B140i controller is disabled, drives connected to the system board Mini-
SAS connectors operate in AHCI or Legacy mode. Under this condition:
• The drives cannot be a part of a hardware RAID or a logical drive.
• The Locate, Drive status, and Do not remove LEDs of the affected drives are disabled.
Use BIOS/Platform Configuration (RBSU) in the UEFI System Utilities to enable or disable the
B140i controller (System Configuration, BIOS/Platform Configuration (RBSU), System Options,SATA
Controller Options, Embedded SATA Configuration).

Low-profile LFF hot-plug drive LED definitions

Item Definition
1 Fault/UID (amber/blue)
2 Online/Activity (green)
LED Activity
Status
Solid green
Flashing green
Flashing amber/green
Flashing amber
Solid amber
Off
Low-profile LFF hot-plug drive LED definitions
Definition
The drive is a member of one or
more logical drives.
The drive is rebuilding or
performing a RAID migration,
strip size migration, capacity
expansion, or logical drive
extension, or is erasing.
The drive is a member of one or
more logical drives and predicts
the drive will fail.
The drive is not configured and
predicts the drive will fail.
The drive has failed.
The drive is not configured by a
RAID controller.
29