Configuring Ipv6 Snooping (Cli) - Cisco Catalyst 3650 Configuration Manual

Configuring Wireless Multicast
Command or Action
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 wireless multicast
Example:
Device(config)# wireless multicast
Step 4 no ap capwap multicast ipaddr
Example:
Device(config)# no ap capwap multicast
231.1.1.1
Step 5
end
Example:
Device(config)# end
Related Topics
Information About Wireless Multicast, on page 216

Configuring IPv6 Snooping (CLI)

SUMMARY STEPS
1. enable
2. configure terminal
3. ipv6 mld snooping
DETAILED STEPS
Command or Action
Step 1 enable
OL-29890-01
Purpose
• Enter your password if prompted.
Enters global command mode.
Enables the multicast traffic for wireless clients and enables mDNS
bridging. The default value is disable. Add no in the command to
disable the multicast traffic for wireless clients and disable mDNS
bridging.
Enables forwarding mode in multicast. Add no in the command
to disable the multicast mode.
Exits the configuration mode. Alternatively, press Ctrl-Z to exit
the configuration mode.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
Configuring IPv6 Snooping (CLI)
Purpose
Enables privileged EXEC mode.
219