Example Enabling Ecmp Multicast Load Splitting Based On Source And Group Address - Cisco Catalyst 3650 Configuration Manual

Example Enabling ECMP Multicast Load Splitting Based on Source and Group Address

Example Enabling ECMP Multicast Load Splitting Based on Source and Group
Address
The following example shows how to enable ECMP multicast load splitting on a router based on source and
group address using the basic S-G-hash algorithm:
ip multicast multipath s-g-hash basic
Related Topics
Enabling ECMP Multicast Load Splitting Based on Source and Group Address, on page 328
ECMP Multicast Load Splitting Based on Source and Group Address Using the Basic S-G-Hash Algorithm,
on page 317
Example Enabling ECMP Multicast Load Splitting Based on Source Group and
Next-Hop Address
The following example shows how to enable ECMP multicast load splitting on a router based on source,
group, and next-hop address using the next-hop-based S-G-hash algorithm:
ip multicast multipath s-g-hash next-hop-based
Related Topics
Enabling ECMP Multicast Load Splitting Based on Source Group and Next-Hop Address, on page 329
ECMP Multicast Load Splitting Based on Source Group and Next-Hop Address, on page 319
Additional References
Related Documents
Related Topic
Cisco IOS commands
Cisco IOS IP Multicast commands
Standards and RFCs
Standard/RFC
RFC 4601
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
332
IP Multicast Optimization: IP Multicast Load Splitting across Equal-Cost Paths
Document Title
Cisco IOS Master Commands List, All Releases
Cisco IOS IP Multicast Command Reference
Title
Protocol Independent Multicast-Sparse Mode
(PIM-SM): Protocol Specification
OL-29890-01