Installing Batteries - Walgreens WGNBPW-930BT Manual

Display Symbols:
User 1: Appears when the monitor is operated by User 1.
User 2: Appears when the monitor is operated by User 2.
Weak Battery Symbol: Appears when batteries should be
replaced.
Pulse Symbol: Shows the heart rate per minute.
Risk Category Index: See page 30 for more information.
Irregular Heartbeat Detector: See page 31 for more
(No Symbol)
information.
Memory Average: Displays average of last 3 readings.
Memory Average: Displays average of last 3 readings.
Wrist Positioning Guide: See page 14 for more information.
Data Transmitting Symbol: Appears when data is transmitting
to your mobile device.
If and any of the following letters and numbers appear in the area
START
M
that systolic pressure should be displayed or the wrist icon appears, an error STOP
has occured with your reading. See Troubleshooting section of this manual for
more information.
Measurement Error: Wrap the cuff correctly and keep wrist
steady during measurement. Measure again.
Air Circuit Abnormality: Measure again.
Pressure Exceeding 300 mmHg: Switch the unit off to clear,
then measure again.
Error Determine Blood Pressure Measurement: Rewrap cuff
properly, keep steady, and measure again.
Data Transmission Error: Monitor cannot connect to the mobile
device to transmit data. Make sure Bluetooth is ON.
System Error: Measure again.
11

INSTALLING BATTERIES

1. The battery cover is located on the back
of the monitor. Remove battery cover
by pressing down and pulling away
from the monitor.
2. Install batteries according to the polarity
indications inside the compartment
(as shown in Figure 2). Battery Type:
2 Alkaline LR03 (AAA) size.
Note: For easy battery removal, place
batteries on top of the ribbon located
inside of the battery compartment.
3. Insert the other battery, according to
the polarity indications inside the
compartment (as shown in Figure 3).
4. Replace the cover by inserting it back
into place.
1.
2.
3.
4.
12