Parameter Settings; Normal Sounds; Preparing The Ice Machine For Long Storage; Operation - Parts Connect IM70 User Manual

Parameter Setting
Status
Ice Making
Short press MODE
Cycle
Note 1: XX is the ice cube thickness and actually refers to the evaporator temperature. The colder
you set, the thicker you get. 00 = 0 degrees Celsius, 01-19 = -1 to -19 degrees Celsius.

Normal Sounds

Your new ice machine may make sounds that are unfamiliar to you. Most of the new sounds are normal.
Hard surfaces like the floor and walls can amplify the sounds. The following describes the kinds of
sounds that might be new to you and what may be causing them.
• Rattling noises may come from the flow of the refrigerant or the water line. Items stored on top of the
ice machine can also make noises.
• The high-efficiency compressor may make a pulsating or high-pitched sound.
• Running water may make a splashing sound.
• You may hear air being forced over the condenser by the condenser fan.
• During the harvest cycle, you may hear the sound of ice cubes falling into the ice storage bin.

Preparing the Ice Machine for Long Storage

If the ice machine will not be used for a long time, or is to be moved to another place, it will be necessary
to drain the system of water.
1. Shut off the water supply at the main water source.
2. Disconnect the water supply line from the water inlet.
3. Shut off the electric supply at main electrical power source.
4. Take out the ice storage bin to remove remaining ice and water. Dry it.
5. Connect the drain hose to drain out water completely, then plug up the drain outlet after finishing.
6. Pull off the drainage tube of the water trough to drain off all water.
7. Leave the door open to allow for circulation and to prevent mold and mildew.
8. Leave water supply line and power cord disconnected until ready to reuse.
IMPORTANT:
• Do not touch the power plug when your hands are wet.
• Never unplug the unit by pulling on the plug.
20

Operation

SMG: shows current
button
light & SMG
number for 2
seconds and then
shows 1xx
Ice making light: on
Details
The parameter 1xx means set the
thickness of the ice cube, xx will
flash during setting. Short press set
button can change the 1xx,
between 100 to 119, 100 is thinner,
119 is thicker. After setting leave it
no-operation for 10 seconds,
system will automatically remember
the setting and go back to the ice
making cycle. Default number is
111. See note 1.