Error Codes - Parts Connect IM70 User Manual

Error
Error Status
Code
1. Ice full swivel is not
E01
functioning correctly
2. Ice full switch is not
functioning properly
E02
Maximum harvest time
E03
of 3 minutes has been
exceeded.
High temperature error
E04
for condenser.
Lack of water.
E05
Condenser temperature
E07
sensor open.
Condenser temperature
E08
sensor shorted.
Evaporator temperature
E09
sensor open.
Evaporator temperature
E10
sensor shorted.
After 30 minutes of the
E11
icemaking procedure,
the evaporator tempera-
ture still higher than
0ºC.
Note: After correcting the problem, short press the Mode button. The ice machine will run properly.

ERROR CODES

lights Reason
Error 1. Ice full swivel is jammed
Light 2. Ice full switch needs to be
ON replaced
Error 1. Ambient temperature is too
Light high.
ON 2. Condenser is too hot.
3. Refrigerant is leaking.
4. Lack of water.
Error 1. Reversing valve problems.
Light 2. Ice cube thickness setting
ON is too thin.
3. Lack of water.
4. Condenser is too cold.
Error 1. Ambient temperature too
Light high.
ON 2. Fan is not functioning.
3. Dust on the condenser.
Error 1. Water supply pressure low.
Light 2. Water valve broken, or
ON water tank leaking.
3. Water sensor is not working.
Sensor broken or terminal is
not connected.
Sensor broken or terminal
shorted
Sensor broken or terminal is
not connected.
Sensor broken or terminal
shorted.
Error 1. Compressor problem.
Light 2. Refrigerant leaking.
ON 3. Condenser is too hot.
Treatment
1. Free swivel of jam.
2. Replace ice full switch
1. Check if condenser is too
hot. Clean it (Page 22) &
make sure the fan is oper-
ating properly.
2. Repair refrigerant leak.
3. Check water inlet..
1. Fix the reversing valve.
2. Set ice cube to normal
thickness.
3. Check water inlet valve.
1. Fix the fan.
2. Clean the condenser.
1. Fix water supply system.
2. Fix the valve or tank.
3. Change the sensor.
Check and fix sensor.
Check and fix sensor.
Check and fix sensor.
Check and fix sensor.
1. Repair the compressor.
2. Repair refrigerant leak.
3. Repair the condenser fan
or clean the condenser.
25