Battery Installation; Battery Storage - Polaris 340 Edge Touring Owner's Manual

Battery

Battery Installation

WARNING
Batteries contain gases that can explode. If the battery vent tube is pinched
or kinked, battery gases could accumulate. Whenever removing or installing
the battery, disconnect the negative (black) cable first and reinstall the nega-
tive cable last to avoid the possibility of explosion.
Battery electrolyte contains acid. Avoid skin contact with electrolyte as
severe burns may result.
1. Place the battery in its holder. Attach the hold down strap.
2. Install the battery vent line. It must be free from obstructions and
securely installed. Route the vent line properly to prevent kinks and
to allow for proper drainage.
3. Connect and tighten the red (positive) cable first.
4. Connect and tighten the black (negative) cable last.
5. Verify that cables and vent hose are properly routed.

Battery Storage

When your snowmobile is placed in storage for one month or more:
• Remove the battery.
• Charge it to the proper level.
• Store it in a cool dry place.
• Check and/or charge monthly.
Before using the battery, take it to your dealer for testing and recharging.
Batteries may freeze if not fully charged, resulting in cell damage.
Charge condition
100%
75%
50%
25%
0%
MAINTENANCE
Will freeze at:
-75_ F(-59_ C)
-24_ F(-31_ C)
0_ F(-18_ C)
+13_ F(-11_ C)
+18_ F(-8_ C)
131