Dodge DURANGO 2018 User Manual page 27

Programming The Memory Feature
NOTE:
To create a new memory profile, perform the
following:
1. Cycle the vehicle's ignition to the ON/RUN
position (do not start the engine).
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror, power tilt
and telescopic steering column [if equipped],
and radio station presets).
3. Push and release the set (S) button on the
memory switch.
4. Within five seconds, push and release either
of the memory buttons (1) or (2). The instru-
ment cluster display will display which
memory position has been set.
NOTE:
• Memory profiles can be set without the vehicle
in PARK, but the vehicle must be in PARK to
recall a memory profile.
• To set a memory profile to your key fob, refer to
"Linking And Unlinking The Remote Keyless
Entry Key Fob To Memory" in this section.
Linking And Unlinking The Remote Keyless
Entry Key Fob To Memory
Your key fobs can be programmed to recall one
of two pre-programmed memory profiles by
pushing the unlock button on the key fob.
NOTE:
Before programming your key fobs you must
select the "Memory Linked To FOB" feature
through the Uconnect system screen. Refer to
"Uconnect Settings" in "Multimedia" in your
Owner's Manual for further information.
To program your key fobs, perform the following:
1. Cycle the vehicle's ignition to the OFF
position.
2. Select a desired memory profile, 1 or 2.
NOTE:
If a memory profile has not already been set,
refer to "Programming The Memory Feature"
in this section for instructions on how to set
a memory profile.
3. Once the profile has been recalled, push and
release the set (S) button on the memory
switch.
4. Within five seconds, push and release button
(1) or (2) accordingly. "Memory Profile Set"
(1 or 2) will display in the instrument cluster.
5. Push and release the lock button on the key
fob within 10 seconds.
NOTE:
Your key fobs can be unlinked to your memory
settings by pushing the set (S) button, and
within 10 seconds, followed by pushing the
unlock button on the key fob.
Memory Position Recall
NOTE:
The vehicle must be in PARK to recall memory
positions. If a recall is attempted when the
vehicle is not in PARK, a message will be dis-
played in the instrument cluster display.
Driver One Memory Position Recall
• To recall the memory settings for driver one
using the memory switch, push memory but-
ton (1) on the memory switch.
• To recall the memory settings for driver one
using the key fob, push the unlock button on
the key fob linked to memory position 1.
25