Controlling Tone-Based Services; Setting Up The Hands-Free Phone - Kenwood DNX9960 Instruction Manual

Hands Free Unit Control
4 Make a call
■ If there is more than one phone
number assigned under the registered
name
5 Say the key word registered for the
category
When a beep is heard, say the category
within 2 seconds.
6 Make a call
64 DNX series DNX9960/ DNX7160/ DNX7020EX
■ If there are more than one phone
numbers registered under the same
name, go to step 7.
7 Select a Phone number category
Selects the Phone number category.
8 Make a call
⁄
• A message is displayed if the voice is not
recognized. Read the message for the further
operation.

Controlling Tone-based Services

Controlling Tone-based Services
Uses tone base service using DTMF (Dual
Tone Multi Frequency).
1 Display the Talking screen
See <Calling by Entering a Phone
Number> (page 62).
2 Display the DTMF input screen
3 You can send tones during a call
DDX series DDX896/ DDX8046BT

Setting Up the Hands-Free Phone

Setting Up the Hands-Free Phone
The Hands-Free system can be set as
follows.
1 Display the Hands-Free Control
screen
See <Making a Call> (page 60).
2 Display the Hands Free Setup screen
3 Set each item
[Auto Response] Sets an automatic
response time after call termination.
( "OFF")
"OFF": This function can not use.
"0-99": Sets to calling ring time
(second).
Next page 3 Next page 3
English 65