Smart Install Mode Was Not Carried Out (Error Code : E508 ) - Samsung AC071MN4PKH Service Manual

Troubleshooting

4-4-22. Smart install mode was not carried out (Error Code : E508 )

Smart install mode?
When installing the air conditioner the first time, the installation status and fault status and performance of the product is a self-diagnostic
function to determine comprehensively..
(The corresponding model is necessarily the general operation can be carried out when the smart install mode.)
Installation procedures of smart install mode
(1) Check the installation status of air conditioner.
▶ Check the power wire, communication wire, power connection, service valve opening, additional amount of refrigerant.
▶ When supplying power upon installation, a warning (error) of not having run in the installation smart install mode is
displayed and the product will not run properly.
Model Indoor unit Outdoor unit
360 Cassette Red lights up E508
(2) Enter the smart install mode.
▶ Enter of the outdoor unit : Press for at the same time 5 seconds K 1, K 4 switches.
▶ Enter of the remote control : Press for at the same time 4 seconds [Power] + [Set] + [Mode] buttons.
▶ The progress status of installation smart install mode is shown in "00~99"(%).
▶ The smart install may take about 10 minutes.
Model Indoor unit Outdoor unit
" " " " " " " "
It is blinking in sequence.
After lasting for 3 minutes
360 Cassette
" " " " " ~ "
(Ice blue Yellow green Blue Red Ice blue)
display
(3) The installation smart install mode is complete.
▶ Success in the installation smart install mode : The unit will enter a general operation standby mode upon blinking to show
a success.
Indoor unit Outdoor unit
Indicator light of main " " " " " " " "
After blinking for 10 seconds,
unit switches off.
it will enter the general operation standby mode.
▶
Smart Install failure: Error code blink
※ In the event of Error Error code reference, please carry a house from scratch after an action mode for the Smart Install Error.
4-54