Setting An Indoor Unit Address And Installation Option - Samsung AC071MN4PKH Service Manual

4. Troubleshooting

4-1 Setting an indoor unit address and installation option

▶ Indoor address set-up and installation options, set the remote control option..
ADDRESS setting and indoor settings option haohni setting is not possible at the same time, set each of the options.
If necessary, set up the indoor address setting installation options, you must enter twice.
4-1-1. The procedure of setting option
▶ MR-EC00 and MR-EH00 remote controls
Entering the
mode for setting
the options
High Temp button
Low Temp button
Enter the mode for setting the options
Step 1
1.Enter the mode for setting the options :
a. R1emove the batteries from the remote control,and then insert them again.
b. While holding down the
c. Make sure that you are entered to the mode forsetting the options:batteries into the remote control.
2. Set the option values.
CAUTION
set values for these options are skipped automatically.
SEG6 and SEG8
SEG20 SEG21 and SEG22
SEG1 SEG2 SEG3
0 X
SEG13 SEG14 SEG15
2 X
(High Temp) and (Low Temp) buttons simultaneously, insert thebatteries into the remote control.
SEG9 and SEG10 SEG11 andSEG12
SEG23 and SEG24
SEG4 SEG5 SEG6
X X X X
SEG16 SEG17 SEG18
X X X X
SEG14 and SEG15
SEG7 SEG8 SEG9 SEG10
1 X X X
SEG19 SEG20 SEG21 SEG22
3 X X X
4-1
Setting the
option values
Mode button
High Fan button
Low Fan button
SEG4 and SEG5
SEG16 and SEG17 SEG18 and
SEG11 SEG12 On (SEG1~12)
X X
SEG23 SEG24
X X
Off (SEG13~24)