Chauvet Vesuvio II Quick Reference Manual page 3

Hide thumbs Also See for Vesuvio II:
Table of Contents

Advertisement

EN
AC Plug
Connection
AC Live
AC Neutral
AC Ground
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
Resetting the Breaker
This product is equipped with a resettable circuit breaker. If the breaker trips, all sections of this product will lose power.
1.
Remove the power cord from mains power.
2.
Allow unit to cool for 15 minutes.
3.
After 15 minutes, you may attempt to reset the breaker by pressing the button with your finger.
4.
Plug the product's power cord into the power outlet and continue using as recommended.
DMX Linking
The Vesuvio II will work with a DMX controller using a 3- or 5-pin DMX data connection for its 1-channel DMX personality.
A DMX Primer is available from www.chauvetprofessional.com.
DMX Connection
The Vesuvio II uses a 3- or 5-pin DMX data connection for its 1-channel DMX personality. See the User Manual for
information about connecting and configuring the product for DMX operation.
Preparing for Operation
To prepare the Vesuvio II for operation:
1.
Open the flight case.
2.
Pull out the fluid tank and remove the cap.
3.
Verify that the two plastic hoses attached to the inside of the cap are in place and in good condition.
4.
Pour Chauvet (QDF) fog fluid inside the tank, and re-cap.
5.
Reinsert the tank.
6.
Make sure that the plastic hose that goes from the cap to the fogger is not bent.
7.
Plug in power and wait approximately 10 minutes for warm-up to complete.
When storing the product, ALWAYS be sure to store the fluid tank with the cap up as seen on the
Product Mounting Diagram above before installing the front cover to avoid tube damage that may
cause leakage.
Only use Chauvet approved (QDF) fog fluid. Otherwise, you might not have satisfactory results.
In addition, unapproved fluid can damage the Vesuvio II or cause harm to humans or animals.
2
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
Wire (Europe)
Brown
Blue
Green/Yellow
Screw Color
Yellow/Brass
Silver
Green
Vesuvio II QRG Rev. 1

Advertisement

Table of Contents
loading

Table of Contents