Skoda Octavia 1996 Service Manual page 33

OCTAVIA
Edition 12.99
S00.5105.52.20
Crank Assembly
- Position crankshaft to TDC of cylinder 1
⇒ page 13-6 (except if engine removed).
- Fit toothed belt onto toothed belt sprocket of
crankshaft (pay attention to direction of
running) ⇒ page 13-5.
Note:
K If engine removed, after this fit on bottom toothed
belt guard and toothed belt sprocket and position
crankshaft to TDC of cylinder 1 -arrows-.
- Fit toothed belt onto tensioning pulley and
camshaft sprocket.
K - Pay attention to installation position of semi-
automatic tensioning pulley:
♦ The retaining claw -arrow- must engage
in the recess on the cylinder head.
K - Turn semi-automatic tensioning pulley with
nut turner T10020 fully to the left as far as
the stop (in direction of arrow).
- Slacken tensioning pulley until notch -1- and
pointer -2- are positioned opposite.
- Tighten clamping nut at the semi-automatic
tensioning pulley to 25 Nm.
- Rotate crankshaft fully twice and check
setting.
- Install bottom toothed belt guard.
- Install vibration damper (pay attention to
installation position: hole of vibration damper
is positioned above the raised section on the
toothed belt sprocket).
13
------------ 13-9 ------------