Cis Element - Contex SD One+ Technical Service Manual

Service Guide SD One+

CIS Element

Tools: T10 Torx Screwdriver.
Prerequisites
Switch power off.
Raise CIS Bridge Unit as shown on page 11.
1. Remove screws and bracket.
2. Remove the glass plate by holding on to each
end without touching the backside.
NOTE. When re-inserting the glass plate, ensure the
edge of the glass is properly seated under the bracket.
NOTE
DO NOT touch the surface of the CIS Element.
3. Carefully flip the CIS Element forward (A) and
slide it to the Left (B).
4. Once free of the hinges lift out the CIS Element.
23