Before You Begin; Location Of Controls - Travis Industries 42 ProBuilder GSB2 Owner's Manual

6

Before You Begin


Read this entire manual before you use your new fireplace (especially the section "Safety Precautions" on
pages 4 & 5). Failure to follow the instructions may result in property damage, bodily injury, or even death.

Location of Controls

There is a door on the lower portion of the screen assembly to provide access to the manual controls on the
fireplace. The door is held closed by two magnets. Open the door by gently pulling outward on the upper
portion of the lower trim.
Shutoff Valve
(accessible with
screen removed)
Flame Adjust Knob
Continuous / Intermittent Pilot Switch
On/Off Switch
Gas Control Knob
Flame Adjust Knob
Continuous Pilot --
GreenSmart Pilot
Optional Remote Receiver The receiver is used in conjunction with the optional remote thermostat. It is used
Optional Blower Dial
© Travis Industries
Operation
On/Off Switch
Optional Blower Dial
Battery Tray - or - Optional Remote Receiver
This control is used to turn the heater on and off.
This knob is used to control gas to the heater and for starting the pilot. There are
three positions, ON, OFF, & PILOT. The pointer to the left of the knob indicates
the position this knob is in.
This knob controls the flame height from low ("LO") to high ("HI"). The pointer
above the knob points to the position this knob is in.
This switch controls how the pilot flame works. See the section "Continuous
Pilot / GreenSmart Pilot" for details.
to control the remote and replaces the on/off switch for direct operation.
This knob controls the speed of the internal convection blower that pushes the
heated air into the room.
Rotate the Control Door Down to
9/21/17 - 1451
Access Controls
PB 42 Lin GSB2 Operation