Specifications; Standard Equipment; Pre-Operation Inspection - RIDGID RP 240 User Manual

Specifications

Attachments ..................RIDGID
Motor:
Voltage.........................12 V DC rated, 10.8 V DC nominal
Amperage....................24.1 A
Power ..........................260 W
Ram Force.....................5,400 lbs. (24 kN)
Head Rotation ...............270°
Duty Cycle.....................3 Press
Battery ...........................12 V Li-Ion Rechargeable Battery Pack (RIDGID RB-1200 Series)
Bluetooth Range ...........33 ft. (10 m)
Ingress Protection .........IP44
Permissible Humidity ....80% maximum
Operating
Temperature ..................15°F to 122°F (-10°C to 50°C)
Weight ...........................5.15 lbs. (2.33 kg)
(No battery/attachment)
Dimensions ...................10.6" x 2.9" x 8.7"

Standard Equipment

Refer to the RIDGID catalog for details on
equipment supplied with specific tool catalog
numbers.
Selection of appropriate materials
NOTI E
and joining methods is the responsibility of
the system designer and/or installer. Before
any installation is attempted, careful evalua-
tion of the specific service environment, in-
cluding chemical environment and service
temperature, should be completed. Consult
Press Fitting System manufacturer for se-
lection information.
Pre-Operation
Inspection
WARNING
Daily before use, inspect your press
tool and correct any problems to re-
duce the risk of serious injury from
electric shock, crushing injures, attach-
ment failure and other causes, and pre-
vent tool damage.
1. Remove battery from tool.
999-995-106.10_REV. A
RP 240 Pistol Press Tool
® Compact Series
/min.
270 mm x 74 mm x 221 mm
RP 240/RP 241 Press Tools
RP 241 Inline Press Tool
RIDGID ® Compact Series
5,400 lbs. (24 kN)
180°
3 Press
5.15 lbs. (2.33 kg)
13.4" x 3.4" x 4.4"
340 mm x 86 mm x 112 mm
2. Clean any oil, grease or dirt from the
equipment, especially the handles and
controls. This aids inspection and helps to
prevent the tool or controls from slipping
from your grip.
3. Inspect the press tool for:
• Proper assembly, maintenance and com -
pleteness.
• Any broken, worn, missing, misaligned
or binding parts. Confirm fabric loop is in
good condition.
• Smooth movement of attachment mount-
ing pin between the fully open and fully
closed position. Pin should lock into each
position. Confirm that the run switch
moves freely and does not bind or stick.
• Presence and readability of warning la-
bels. See Figure 6.
• Any other condition which may prevent
safe and normal operation.
Do not use the press tool until any prob-
lems have been repaired.
4. Inspect and maintain tool attachments
per their instructions. Remove attach-
ment from the tool. Confirm that attach-
ments are in good condition and clearly
marked as to use.
5. Inspect and maintain any other equip-
ment being used per its instructions to
make sure it is functioning properly.
/min
7