Inspecting The Pressed Connection; Bluetooth Functions (Wireless Data Transfer); Cold Weather Operation - RIDGID RP 240 User Manual

RP 240/RP 241 Press Tools
Figure 9 – Installing Press Ring onto Fitting
Figure 10 – Attaching Actuator to Press Ring
4. Release the run switch.
5. Squeeze actuator arms to open actuator.
Remove actuator from fitting.
6. Remove ring from fitting. Avoid sharp
edges that may have formed on fitting
during pressing operation.
7 . When operation is complete, depress
On/Off button one time to turn tool OFF.
Remove battery from tool.
Inspecting The Pressed
Connection
1. Inspect the pressed fitting for:
• Full insertion of tube into fitting.
• Excessive misalignment of the tubes.
A slight amount of misalignment at a
pressed connection is considered nor-
mal.
• Incorrect attachment alignment with the
fitting contour. Distorted or deformed fit-
ting.
• Any other issues per the fitting manu-
The Bluetooth ® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc., and any use of such marks
by Emerson Electric Co. is under license. Other trademarks and trade names are those of their respective owners.
iOS is registered trademark of Apple Inc.
Android and the Android logo are trademarks of Google Inc.
10
facturer. This could include the removal
of a control ring or decal (used to indi-
cate the connection has not yet been
pressed).
If any issues are found, remove fitting
and install a new connection.
2. Test connection in accordance with con-
nector manufacturer instructions, normal
practice and applicable codes.
Bluetooth Functions (Wireless
Data Transfer)
The RIDGID ® RP 240 and RP 241 Press Tools
include Bluetooth ® wireless technology allow-
ing wireless data transfer to properly equipped
smartphones or tablets ("devices") running
iOS or Android operating systems.
1. Download the appropriate RIDGID
your device by going to RIDGID.com/apps
or by going to the Google Play Store or
Apple App Store.
2. When the tool is ON, a Bluetooth wireless
technology equipped device can find and
pair with the press tool.
3. In the Bluetooth settings of your device,
select desired RIDGID tool. Refer to your
device instructions for specific informa-
tion on how to connect via Bluetooth wire-
less technology. Once connected, the
blue tool status light will be solid.
After the initial pairing, most devices will
automatically connect to the Tools when
the Bluetooth wireless technology is ac-
tive and in range. Press tools should be
less than 33 ft. (10 m) from the device to
be detected. Any obstacle between the
tool and device can reduce the opera-
tional range.
4. Follow the app instructions for proper
use. Among other things, the app allows
monitoring of tool cycles and the tool to
be locked to prevent unauthorized use.
5. The wireless data transfer turns OFF
when the press tool is switched OFF.
Turn Bluetooth wireless device OFF to
reduce device battery drain.

Cold Weather Operation

As temperature drops, hydraulic fluid thickens
and battery performance degrades. To reduce
® app to
999-995-106.10_REV. A