2.3.3 DDC/CI
DDC/CI (Command Interface) specifies a means for a computer to send commands to the monitor,
as well as receive sensor data from the monitor, over the bidirectional link such as DDC2Ab/Bi/B+.
Specific commands to control monitors are defined in a separate Monitor Control Command Set
(MCCS) standard.
DDC/CI monitors are sometimes supplied with an external color sensor to allow automatic
calibration of the monitor's color balance. Some tilting DDC/CI monitors support an auto pivot
function, where a rotation sensor in the monitor enables the operating system to keep the display
upright as the monitor is moved between its portrait and landscape positions.
The following DDC/CI commands should be supported via command line:
No.
1
Set Brightness
2
Set Contrast
3
Set Red Gain
4
Set Green Gain
5
Set Blue Gain
6
Get Brightness
7
Get Contrast
8
Get Red Gain
9
Get Green Gain
10
Get Blue Gain
2.4
Service mode
Detailed technical specification refers to Service delta technical specs.
•
Software Update:
Through RS-232
2.5 Power Supply
2.5.1 Power supply features
•
AC line voltage range -
•
AC line frequency range -
•
DC tact switch -
•
AC mains switch -
•
Inrush current -
•
Leakage current -
•
Power factor correction -
General Product Specification
Commands
90Vac ~ 264Vac.
50-60 Hz ± 3 Hz.
Minimal power consumption when switch off
No power consumption when switch off.
< 40A at 240Vac when cold start.
< 0.5mA at 240Vac.
According to EN61000-3-2
BDL6531E LCD
69