Lock/Unlock, Factory Mode, Burn In; Service Mode - Philips M32 107T4 GS_3 Service Manual

Lock/Unlock, Factory Mode, Burn In, Service Mode
Front Control
Power button switches your monitor on.
OK button which when pressed will take you to the OSD
controls
Contrast hotkey. When the UP arrow is pressed, the
adjustment controls for the CONTRAST will show up.
UP and DOWN buttons are used when adjusting the OSD of
your monitor
B
rightness hotkey. When the RIGHT arrow is pressed,
the adjustment controls for BRIGHTNESS will show up.
LEFT and RIGHT buttons, like the UP and DOWN buttons, are
also used in adjusting the OSD of your monitor.
OSD Lock
OSD lock is a feature which disables the OSD controls. It can be used
when the monitor is set up for demonstration purposes or when
adjustment of the OSD is not desirable.
Switch on OSD lock feature:
Press and hold the button continuously for 15 seconds.
Release the button when the message
"CONTROL MENU IS LOCKED" appears.
Switch off OSD lock feature:
Press and hold the button continuously for 15 seconds or until the
message window "CONTROL MENU IS LOCKED" disappears, and
"MAIN CONTROLS" appears.
Default setting of MODEL SELECT (Do not change it.)
MODEL SELECT
107E4
107E4 (TILT REVERSE)
107T4
107T4 (TILT REVERSE)
RESERVE
SWDDC
LF2
LF3
To access factory mode
1. Turn off monitor (don't turn off PC)
2. Press " " and " " simultaneously on the front control
panel,then press " ",wait till the OSD menu with characters
M32 107E/T4P V2.0 20020523 (below OSD menu)" come on the
screen of monitor.
MODEL SELECT
Factory
Mode
Indicator
M32 107E/T4P V2.0 20020523
3. If OSD menu disappears on the screen of monitor, press "
again (anytime), then the OSD menu comes on the screen again.
4. Using " " : to select OSD menu.
5. Using " " : to increase or decrease the setting.
6. Using " " to access/confirm the selection.
To leave factory mode
7. After alignment of factory mode, turn off monitor (if you do not turn
off monitor, the OSD menu is always at the factory mode), then
turn on monitor again (at this moment, the OSD menu goes back
to user mode).
To access BURN IN mode
First of all, monitor displays an image.
1. Disconnect the video cable (interface cable).
2. Turn off monitor
3. Press " " and " " simultaneously on the front control
panel,then the BURN IN mode comes on the screen of monitor
as below.
50 seconds around
5 seconds around
repeatly
4. Reconnect the video cable, then return to normal image.
SERVICE MODE (Indication-Factory mode)
00010
MODEL SELECT
M32 107E/T4P V2.00 20020523
M32 107T4 GS_3 13
Go to cover page
"
00010: stands for
1. using 10 hours already.
2. turn on/off 10 times.
3. using several hours
+ turn on/off monitor.