Product Range; Electrical Requirements; Standard Testing Conditions; Video / Audio Input Signals - Philips BDL6531E/00 Service Manual

64 BDL6531E LCD

1.2 Product Range

Display
BDL6531E/00
BDL6531E/00
BDL6531E/00

2. ELECTRICAL REQUIREMENTS

All performance specifications are defined under "STANDARD TESTING CONDITIONS", unless
otherwise specified.
2.1

Standard Testing Conditions

•
Warm up time -
•
Ambient temperature -
•
Ambient light -
•
Relative humidity -
•
Barometric pressure -
•
Dark room conditions -
2.2

Video / Audio Input Signals

2.2.1

PC input signal requirements

Pixel rate capability -
VGA sync input -
HDMI input -
VGA analog RGB level - 0 ~ 700mV linear, positive polarity, terminated with 75Ω
I²C DDC signal -
display is
blocking diodes
Preset timings -
General Product Specification
Destination
EU
AUS, CN
US
≥ 30 min.
15°C ~35 °C.
400-600 lux
25% ~ 75%.
860 mbar ~ 1013 mbar.
< 1 lux for optical measurements
86 MHz.
TTL level, separate H/V sync only, "+" or "-" polarity,
terminated with ≥ 2.2kΩ impedance.
TMDS channel:
Carries video data.
Signaling method: According to DVI 1.0 specification.
Single-link (Type A HDMI).
Video pixel rate: 25 MHz to 165 MHz (Type A)
DDC channel:
Allows source to interrogate capabilities of sink.
I²C signaling with 100 kHz clock.
E-EDID data structure according to EIA/CEA-861B
and VESA Enhanced EDID.
impedance.
DDC2B required, DDC serial Data & Clock, DDC components are
connected to both display Vcc and DDC +5V (from PC via video
cable), that the PC can read the DDC data also when the
26 preset modes sets, 15 factory preset mode sets, timing, size
and centering have been pre-aligned in factory according to
specifications.
Mains Cord
EU, UK
CN, UK
NA
powered off. To prevent current feedback into PC,
are required at display side.
Cabinet Color
Generic Black
Generic Black
Generic Black