Rack-Mount The Chassis On A 2-Post Rack - Cisco NCS 5501 Hardware Installation Manual

Rack-Mount the Chassis on a 2-Post Rack

b) Repeat with the other rack-mount guides on the other side of the router.
Step 4
Install the slider rails to the rack as follows:
a) Position the slider rails at the desired levels on the back side of the rack and use two 12-24 screws or two 10-32
screws, depending on the rack thread type, to attach the rails to the rack.
Note For racks with square holes, you might need to position a 12-24 cage nut behind each mounting hole in a
slider rail before using a 12-24 screw.
b) Repeat with the other slider rail on the other side of the rack.
c) Use a tape measure and level to verify that the rails are at the same height and horizontal.
Step 5 Insert the router into the rack and attach it as follows:
a) Holding the router with both hands, position the back of the router between the front posts of the rack.
b) Align the two rack-mount guides on either side of the router with the slider rails installed in the rack. Slide the
rack-mount guides onto the slider rails, and then gently slide the router all the way into the rack.
Note If the router does not slide easily, try realigning the rack-mount guides on the slider
rails.
c) Holding the chassis level, insert two screws (12-24 or 10-32, depending on the rack type) through the holes in each
of the rack-mount brackets and into the cage nuts or threaded holes in the rack-mounting rail.
d) Tighten the 10-32 screws to 20 in-lb (2.26 N.m) or tighten the 12-24 screws to 30 in-lb (3.39 N.m).
Rack-Mount the Chassis on a 2-Post Rack
Note The Cisco NCS-55A1-24H, Cisco NCS 5501 and Cisco NCS 5501-SE can be installed in 4-post rack and
2-post rack.
This section describes how to use the rack-mount kit provided with the router to install the Cisco
NCS-55A1-24H, Cisco NCS 5501 and Cisco NCS 5501-SE router into a cabinet or 2-post rack.
If the rack is on wheels, ensure that the brakes are engaged or that the rack is otherwise stabilized.
Caution
The following table lists the items contained in the rack-mount kit provided with the routers.
Table 5: Cisco NCS-55A1-24H, Cisco NCS 5501 and Cisco NCS 5501-SE Router Rack-Mount Kit
Quantity
2
8
Step 1 Install two rack-mount brackets to the router as follows:
Hardware Installation Guide for Cisco NCS 5500 Series Fixed-Port Routers
22
Part Description
Rack-mount brackets
M4 x 0.7 x 6-mm Phillips flat-head screws
Install the Chassis