Linksys WRVS4400N Manual page 78

VPN Tab
Summary
Tunnels Used Displays the number of tunnels used.
Tunnel(s) Available Displays the number of available tunnels.
Detail button Click Detail to display more tunnel information.
Tunnel Status
No. Displays the number of the tunnel.
Name Displays the name of the tunnel, as defined by the Tunnel Name field on the VPN
> IPSec VPN screen.
Status Displays the tunnel's status: Connected, Hostname Resolution Failed, Resolving
Hostname, or Waiting for Connection.
Phase Enc/Auth. Displays the Phase 2 Encryption type (3DES), Authentication type
(MD5 or SHA1), and Group (768-bit, 1024-bit, or 1536-bit) that you chose in the VPN >
IPSec VPN screen.
Local Group Displays the IP address and subnet of the local group.
Remote Group Displays the IP address and subnet of the remote group.
Remote Gateway Displays the IP address of the remote gateway.
Tunnel Test Click Connect to verify the tunnel status; the test result is updated in the
Status column. If the tunnel is connected, you can disconnect the IPSec VPN connection
by clicking Disconnect.
Config Click Edit to change the tunnel's settings. Click Trash to delete all of the tunnel's
settings.
Tunnel(s) Enabled Displays the total number of currently enabled tunnels.
Tunnel(s) Defined Displays the number of tunnels currently defined. This number will
be greater than the Tunnels Enabled field if any defined tunnels have been disabled.