Administration Tab - Linksys WRVS4400N Manual

QoS
The Router support two types of Quality of Service (QoS) traffic.
•Bandwidth Management. This allows you to perform Bandwidth Management, by either Rate Control or
Priority.
•QoS Setup. This allows users to configure QoS Trust Mode for each LAN port.
•DSCP Settings. This allows you to set the DSCP (Differentiated Services Code Point) settings.
Administration
You will use Administration tabs for systems administration purposes.
•Management. You can alter the Router's password, its access privileges, SNMP settings, and UPnP
settings on this screen.
•Log. This screen allows the configuration of Log settings.
•Diagnostic. This screen allows you to run ping tests and display test results.
•Backup & Restore. You can back up and restore the Gateway's configuration file in this screen.
•Factory Defaults. If you need to restore the Router's factory defaults, use this screen.
•Reboot. Use this screen to reboot the Router.
•Firmware Upgrade. Use this screen to upgrade the Router's firmware.
IPS
You will use this tab for advanced configuration on built-in Intrusion Prevention System (IPS) inside the
Router.
•Configuration. Enable or disable IPS functions from this screen.
•P2P/IM. Allows or blocks specific Peer to Peer (P2P) networks and Instant Messaging (IM) applications.
•Report. Provides reports of network traffic and malicious attacks.
• Information. Provides the signature file version and the Protection Scope of the IPS system.
L2 Switch
You will use this tab to configure layer 2 switching features on the 4 port Ethernet Switch (LAN ports only).
•Create VLAN. Virtual Local Area Network (VLAN) assignment is done on this screen.
•VLAN & Port Assignment. Virtual Local Area Network (VLAN) and Port settings are done on this screen.
•RADIUS. Used for configuration of Remote Authorization Dial-In User Service (RADIUS) settings.
•Port Setting. Allows configuration of port speeds and duplex.
•Statistics. This screen displays statistics for both received and transmitted packets..
•Port Mirroring. Allows configuration of port mirroring.
•RSTP. Used for RSTP (Rapid Spanning Tree Protocol) configuration.
Status
You will use this tab to get the current status on the Router.
•Gateway. This screen provides basic information like firmware version and status information on the
WAN port.
•Local Network. This screen provides status information about the local network (four Ethernet Ports).
•Wireless LAN. This screen provides status information on Wireless LAN.
•System Performance. This screen provides traffic statistics on LAN and Wireless LAN ports.
Setup
The Setup screen contains all of the Router's basic setup functions. The Router can be
used in most network settings without changing any of the default values. Some users