Table of Contents
Advertisement
4
Before You Begin
To prevent unauthorized user access, change the default username and password
before proceeding. See
For security reasons, DO NOT configure your SVG1202 Wireless Voice Gateway over a
wireless network connection.
After installing the gateway, you are now ready to connect your computer and other network devices to
the Internet. To do this, you may have to enable the network options on your computer to automatically
obtain an IP address and DNS server address. Follow the steps in this section for your operating
system.
Note: Your computer may already be configured to automatically connect to the Internet. If so, do not
perform any of the steps in this section.
Configuring TCP/IP for Windows 7
1. Click Start and then select Network, Properties.
2. Click Network and Internet to open the Network and Internet window.
3. Click Network and Sharing Center to open the Network and Sharing Center window.
4. Click Change adapter settings to open the Network Connections window.
5. Right-click the network connection for your network interface.
6. Select Properties to open the Local Area Connection Properties window.
7. Select Internet Protocol Version 4 (TCP/IPv4) and click Properties to open the Internet Protocol
Properties window.
8. Select Obtain an IP address automatically and Obtain DNS server address automatically.
9. Click OK to save the TCP/IP settings and close the Internet Protocol Version 4 (TCP/IPv4)
Properties window.
10. Click Close to close the Local Area Connection Properties window.
11. Close the remaining windows and exit the Control Panel.
12. When you complete the TCP/IP configuration, verify the IP address. See
Windows 7
for more information.
Configuring TCP/IP for Windows Vista
1. Click Start and then right-click Network.
2. Click Network and Internet to open the Network and Internet window.
3. Click Network and Sharing Center to open the Network and Sharing Center window.
4. Click Manage Network Connections.
5. Right-click on the Local Area Connection you want to configure (if more than one is listed).
6. Click Properties to open the Connection Properties window.
7. Click Continue, if prompted for administrator permission.
8. Click Networking tab.
SVG1202 Wireless Voice Gateway • User Guide
Connecting to the Internet
Changing the SVG1202 Default Password
B
for more information.
Verifying the IP Address in
8
Advertisement
Table of Contents
